Using Smart Slice

Interpreting results

Smart Slice generates results for Validate and Optimize operations. Interpretation of these results is discussed here.

Interpreting Validate results

After completing a Validation Smart Slice displays 1 of 2 messages: “Requirements not met!” or “Part appears overdesigned”. In both scenarios, the minimum factor of safety and maximum displacement computed by Smart Slice are presented. The computed values are listed alongside the target values (aka the requirements) specified by the user.

  • “Requirements not met!” means that at least one of the computed values fails to meet the associated requirement. For example, if the computed minimum factor of safety = 0.9 and the target = 2.0, then the factor of safety requirement is not met.

  • “Part appears overdesigned” means that both computed values exceed the requirements.  

validate_results.png

Running an Optimization is recommended in either case. If the part is underdesigned, Optimize will automatically find the print settings that meet or exceed the requirements. If the part is overdesigned that means material can be removed from the part and it will still meet the requirements. Optimize will automatically find print settings that meet the requirements and ensure that print time and part mass are minimized.

Interpreting Optimize results

When an Optimization successfully completes, a table of print setting configurations is shown. The configurations in this table all meet the factor of safety and displacement requirements. Select a configuration from the table to view the print settings and any modifier meshes associated with the configuration. Not all solutions will contain a modifier mesh. The table can be sorted based on any of the column labels (build time, max displacement, etc.). The default ranking is based on ????. Select any configuration from the table and proceed to the Preview stage to slice and print the part with those settings and modifier mesh(es).

An example of a successful Optimization is shown below. In this example, the computed minimum factor of safety is equal to the target and the computed maximum displacement is less than the target. It is rare for a solution to exactly match both the factor of safety and displacement target values. Most of the time, the solution is driven by the stiffness requirement or the strength requirement, not both.

optimize_results.png

It is possible that Smart Slice will be unable to find a print setting configuration that meets the requirements defined by the user. See the optimization method overview for more details.

Next Gen Tools for Next Gen Parts

Get Started with Smart Slice

1938 E Harney Street, Laramie, WY 82072
1-307-314-2891   | 
 info@tetonsim.com

  • linked-in
  • twitter
  • youtube